Top Tips to Get Rid of Linksys Router Red Light Issue

Top Tips to Get Rid of Linksys Router Red Light Issue

Are you tired of seeing the blinking red LED on your Linksys wireless router? Well, we understand what you and many other users are going through. That is why we've written this post. Here, we've mentioned some of the most effective tips that'll help you get rid of the Linksys router red light issue in a flash! So, read on.

Troubleshooting Linksys Router Red Light Issue

Check the Power Connection

One of the biggest reasons why you're facing the Linksys router red light issue is because your device isn't getting enough power supply from the wall socket.

Therefore, check whether the wall outlet to which your wireless router is connected is working properly or not. If not, then it is recommended that you plug your device into another wall socket. Also, make sure that after turning on your router, the power LED is blinking green.

Verify the Ethernet Connection

Loose and faulty Ethernet connection can also result in the Linksys router red light issue. To troubleshoot the issue, make sure that the Ethernet cable connecting your router and the existing modem is not damaged from anywhere.

On the off chance, it is, then waste no more time in getting the Ethernet cable replaced with a new one. Once done, check whether the red light issue has been resolved or not. No?

Update the Firmware

If you are still struggling with the Linksys router red light issue, that's probably because of an outdated firmware. Thus, update the firmware of your wireless device to the latest version right away!

Worry not! Updating the firmware of your Linksys device isn't rocket science. All you need to do is, go through the below-mentioned guidelines:

  • Launch an internet browser on your laptop.
  • Access the default Linksys router IP.
  • Once logged in, head over to Settings.
  • Select Firmware Update under Administration.

In this way, you'll be able to update the firmware of your Linksys WiFi router to the latest version.

Get in Touch with Your ISP

Chances are that you didn't do anything wrong. Perhaps, you're experiencing the Linksys router red light issue because of something that your Internet Service Provider did.

To confirm the same, contact your Internet Service Provider (ISP). If what we are saying turns out to be true, ask him to get the issue fixed as soon as possible.

Reset Your Linksys Router

Is your Linksys WiFi router still blinking red? If sadly, the answer is yes, then you are left with no other option than to reset your wireless device.

Mentioned below are guidelines that will help you restore your Linksys router to the factory default settings:

  • Open an internet browser on your computer.
  • Access the Linksys router setup page and go to Settings.
  • Select the Reset option.
  • A dialogue box will appear. Confirm your decision by clicking Yes.
  • Click Yes and wait a couple of seconds for your device get restored to the default factory settings.

Once your Linksys router resets, reconfigure it by following the steps given in the user manual.

Note: If you are facing the red light issue with your Linksys extender, then consider resetting it too. As soon as you are done, configure your device via Linksys extender setup xxx.

The Bottom Line

This was all about the top tips to get rid of the Linksys router red light issue. Let's hope that the aforementioned tips helped you cope up with the constant blinking of the red LED. However, if you are still struggling with the same issue, don't hesitate to reach out to our technical experts. They are available for you 24/7.